How To Attach Christmas Lights To A Masonry Wall

If you prefer having the lights stick out from the wall instead place a dot of glue under the base of each socket.

How to attach christmas lights to a masonry wall.

They can damage walls and interior surfaces plus. Stick a small adhesive decorating clip to the walls in each place you want to attach a strand of lights. To use a clip just snap it over the brick vertically in the location where you want it to hold the light string. What adhesive will stick to brick.

Apply firm and steady pressure to your drill making sure you re at right angles to the wall s surface. Hold it for about 10 seconds which should be enough time for the glue to cool and the light to adhere to the brick surface. Start at one end and apply hot glue along the side of the base of the light then press it firmly against the brick. Spread a thin layer of glue on the wet part of the brick more is less in this case press and hold the.

To remove the light simply shake the base a bit which will release it from the brick. Lay out your string of lights to ensure you have enough length to work with. Masonry fasteners and anchors are permanently placed into concrete brick and stucco but are complete overkill for hanging christmas lights. The bulbs will be perpendicular to the wall once you finish hanging them.

Start at one end and apply hot glue along the side of the base of the light then press it firmly against the brick. Clean the bricks with a rag brush or broom to get all dirt and debris off the surface of the bricks wet a sponge and wipe across the surface of the brick. You ll need yellow wall plugs a drill with 5mm masonry bit and a dustpan brush set the drill to the hammer setting.