How To Attach Bathroom Sink To Wall

Measure and mark the location of the sink on the wall again.

How to attach bathroom sink to wall.

Installing a bathroom sink in a vanity is made easier by the fact that the supply lines and the drain all remain hidden within a cabinet. Verify the toggled wings open once you. Install the sink if your sink includes a mounting plate you can use that for a template to drill your pilot holes. Remove the current sink by sliding the edge of a putty knife around the perimeter of the bathroom sink loosening any caulk that connects it.

Then turn on the faucet. Set the sink on top of the pedestal then slide the sink close enough to the wall so you can insert the winged toggles into the mounting holes in the wall. Use plumber s putty as you attach the. Lift the back edge of the sink onto the bracket.

Prepare the faucet drain and pop up. Use your hands or locking pliers to unscrew the nut. Two on the rear against the wall and one on each side. Have a small bucket ready to catch any water.

Check the level again before trimming the shims with a utility knife. Turn off the water supply. Loosen the slip nut at the top of the p trap. Follow manufacturer s directions for the size and depth of.

The standard cast iron brackets available for vintage sinks do not seem designed for this sink s brackets. Smear pipe dope onto the threads of the supply line compression fittings and tighten them onto the faucet supply lines. For sinks that do not attach with a bracket ask an assistant to hold the sink at the wall so the upper holes at the rear underside of the sink. Drill your pilot holes for the lag screws which should be included with your wall mount sink.

Slip the sink over the mounting bolts and finger tighten the mounting nuts over the washers. Lift the sink slightly while tightening the nuts with a wrench. If the cabinet has no back simply attach it to the wall so it encloses the plumbing. Attach the sink 1.

Attach the vanity to the wall using 3 inch drywall screws. Remove the entire trap if necessary. If the holes are not completely lining up or you want a more. Be sure to use a masonry.

Use the template that comes with the sink to mark the. If not turn off the water at the main valve. The valves are typically under the sink. Mount the sink to the wall.

If the cabinet has a back you ll need to measure and cut three holes for the two supply lines and the drain. Locate the large nut that connects the sink to the drain and disconnect it. Drill pilot holes into the wall at the marked locations. The pockets are not deep enough for the tabs on my sink the holes do not align etc.