How To Attach A Shower Door

Attach the seal strip to the bottom of the door and cut it to the required length.

How to attach a shower door.

We have a frameless glass shower door that we put a couple handles in the wrong place. Place end caps on the tops of the wall channels. A new shower door can drastically enhance both the form function of your bathroom. Any suggestions on an adhesive that will work.

The frame should be able to support the weight of the door without any wobbling or extra movement. Then align the holes in the wall jamb with the holes or screw anchors in the wall. Make sure each screw is nice and secure but not overly tight. Install the inside door by slipping the top of the door panel into the upper inside channel then swinging the bottom of the door panel into the lower inside track.

Work on one wall jamb at a time and follow these steps. Kohler will only sell us a set of 4 handles when all we need is the adhesive to attach the two handles that we removed. Remove the screw on the interior lever of the door exposing the place for the magnet strip clear the space where the magnetic strip will be placed cut the magnet strip according to the size of the space apply the glue of your choice to the back of the magnet. Attach the door handles and any towel bars.

Attach the door to the jamb. We used dental floss to remove the handles from the glass but now need to reattach them. Stabilize the assembly by drilling a pilot hole and driving a inch screw through the outside face of the base track wherever it meets a vertical frame member. Install the door handles that come with the kit.

Position the inside door panel against the vertical wall frame nearest the showerhead. Secure the jamb with the screws supplied by the manufacturer or the anchor. Monica mangin from the weekender walks you through the steps to installi. The interior door goes in first and then the exterior door is installed from the bottom up.

Place the glass clamp sweep into place on the door s bottom edge and secure it at the door clamp. Align the outside door handle with the holes in the doorframe. Place one wall jamb into or over the bottom track depending on the design. Attach the interior handle and tighten the setscrews.

Add the door once everything is screwed and snapped into place the roller wheels go on the doors and the doors themselves are lifted into place image 1.