How To Adjust Side Springs On Overhead Garage Door

Retest the door balance as you did in step 1.

How to adjust side springs on overhead garage door.

A garage door that is not attached to the springs can fall and cause injury. Failure to install the torsion springs on the correct side will cause your door to function improperly and could result in serious injury. If the garage door isn t opening or closing properly then check the tension on the torsion springs for needed adjustments. Release the tension on the springs by opening your garage door all the way and securing it in place with a c clamp.

Brace door before adjusting extension springs. This video applies t. These types of springs can be adjusted by the. To adjust your garage door s side mounted springs first open your door fully and secure it in place with a c clamp below the bottom roller.

Once your garage door is secured remove the spring hook from the track hanger which will allow you to move the hook and adjust the spring s tension. Torsion springs are mounted directly above the door and need to be wound with special tools. The springs are located at the top inside part of the garage door. Adjust the springs on both sides of the door the same way.

See below to make sure the door is secured before you work on it. This tension makes it easier to lift the garage door from its closed position. The springs extend along the shaft and work by twisting as the garage door closes by means of cables attached to each side of the lowest garage door panel. Once the spring is free of tension remove from its track hanger.

Side mounted springs are long heavy springs mounted on each side of the upper garage door track. Extension springs stretch along the top track on each side. Then disconnect any existing safety cables and remove them away from the door springs. If it was opening too quickly move it to the next lower hole.

Adjustments to these types of spring should only be done by a professional. Tips for adjusting side mounted springs. There are two torsion springs at each side of the garage door. If the door was closing too quickly move the spring to the next higher hole on the bracket.

There are two different types of spring systems for garage doors. To be able to adjust the springs the door must be in a position that release the tension on the springs.