How To Adjust Garage Door Closing Force

Garage door openers make life convenient.

How to adjust garage door closing force.

Changes are necessary if the door reverses during closing moves with too much force or strikes the ground and moves back to the top. Turn the adjustment screw on the limit clockwise if the door doesn t fully close. Step 1 adjust the limit. Reverse by itself without grasping the bottom of the garage door then increase the down close force by turning the adjustment screw clockwise.

The screws are fairly sensitive so it should not take to much adjusment to get the door to close properly. The limit switches on a garage door opener set the travel of the door. Test by opening and closing the door. You ll never need to step outside to get your car in or out of the garage again.

Adjusting these dials alters how far the garage door travels while closing and how much force in kilograms the motor uses. At least that s the theory. Locate the open force and close force controls to the right of the travel limit and set buttons on the power head unit control panel. To change the down force and the up force of your opener find the force adjustment knob and turn it to adjust the up force or down force.

When you have made your adjustment test the door by lowering and raising it. A garage door opener with an improperly adjusted closing force can damage the door or worse injure a child or pet that accidentally walks under the door. How to adjust a garage door to close completely. Adjusting the opener limit switches.

Make small adjustments at a time to the force limits retesting after each adjustment. Adjust the force adjustment screw per the directions in the manual. The closing force of the door works as a. To open the door completely adjust garage door opener by turning the limit counterclockwise.

Once the down close force adjustment is set you will set the up open force limit. Adjust the close force control to change the amount of force your garage door opener uses to close the door. Two dials on the side of the motor head regulate the down settings. With a screwdriver adjust these screws.

Test and adjust the door opener s reverse feature.