How To Adjust Fire Door Hinges

Place the locking pin nearer to the door and release the spring pressure.

How to adjust fire door hinges.

Unscrew the locking screws from the top hinge. Rotate the locking pin to remove and replace the pin one hole further away from the door. Remove the pin with a pliers. Over time the hinges on a door can loosen and cause the door to sag downward.

Rotate the wrench until the next hole comes into view and install the pin. Tightening the door. When this happens the top corner of the door catches on the door frame and prevents the door from closing properly. Close the door completely.

To loosen first close the door. Insert a hex wrench into the. Stand on the side of the door with the hinges and shut the door until it latches. This hole is normally located either at the top or the bottom of the hinge s housing.

Place the hex wrench into the socket at the top of the spring hinge and turn in either direction to release tension on the pin. Changing tension with a hex wrench 1. Check the top of the hinge to see if it has a screw which protects. If the top corner of your door is catching on the frame you ll need to adjust the hinges 1 x research source another step 2 tighten the screws on the door hinges with a screwdriver.

Tighten or loosen in small steps. With a small screwdriver you can adjust the door left and right back and forth and up and down as well. Find the hole beside the locking pin on the hinge s spring which is usually either at the top of bottom of the hinge s housing. Step 1 examine the top corner of your door to see if it s catching on the frame.

Insert a nail set on a hole located beside the locking pin of the hinge adjustment spring. If it does not fully close the hinge will need tightening. Kitchen and bathroom cabinet door hinges are really easy to adjust. I ll bet that you never knew you could adjust a self closing door hing.

Remove the locking pin by rotating the adjustment in the direction of the jamb. You may need to remove the soft closer or a cover cap if there is one to expose the adjustment screw heads.