To set a cuckoo clock you ll need to hang the clock on a wall start it then turn the minute hand to the right time.
How do i set my pendulum wall clock.
Place a wedge underneath the clock in the place needed to maintain this angle.
Pendulum clocks with a time adjustment nut grandfather clocks most wall clocks german mantel clocks shelf clocks etc the adjustment nut is a large nut at the bottom of the pendulum just below the large disk or weight called the bob.
This can be done by either try leveling again from left to right by moving the clock very slightly from the bottom until you hear the most even tick tock.
The centre motion of the crutch must be in the centre of the clock.
Adjust your pendulum clock to the correct time and then set the clock on a level surface and check that it is wound appropriately or not.
The pendulum crutch is a small piece of wire that goes through the pendulum arm.
Step 2 open the access panel door to the pendulum and bring it to a stop.
Check the position of the minute hand of the clock when the top of the hour strike occurs.
1 adjustment nut on the pendulum if your clock has a small nut on the bottom or another place on of the pendulum then use this method.
Make certain the time is correctly set to am or pm.
Setting the time on a strike pendulum clock may be all that is needed to synchronize the chimes.
As the hand forwards through time chimes will sound but just keep moving the hand to the correct time.
Continue turning the small hand in the same direction if there is no strike.
2 check your clock against accurate timepiece or computer.
Then wind the clock by gently pulling the chain without a weight on it towards the floor.
Using a gentle hand bend the crutch in the middle of its length to the desired position.
To set the clock in beat reposition the crutch of the pendulum.
To change between am and pm pass 12 o clock with the clock hand.
Then you need to swing the ball to the left for it to start.
Listen for the strike of the clock.
To slow down the clock loosen the adjustment nut turn it toward your left.
Start with the clock hanging vertically on the wall.
Turn the smaller minute hand counterclockwise to number six.
If a wedge alone will not hold the seth thomas grandfather clock in the proper position try lifting the clock slightly up against the wall.
Set the time on the pendulum clock.
Set the clock to the correct time by turning the hand clockwise.
Note the clock position in which the pendulum swings freely.
To adjust the regulation the pendulum rating nut must be turned and the amount depends on how much time the clock is in error.
If it is a few minutes before or after the hour when the clock strikes the minute hand requires an adjustment.
Setting the beat of the pendulum clock if the beat is irregular like.