Hoover Washing Machine Door Lock Problem

A fault inside the main pcb or even an open circuit motor or heating element on some washing machines can result bizarrely in the door lock activating and locking with displays and lights coming on but washer will not do anything at all.

Hoover washing machine door lock problem.

Before any major repairs check the general condition. If you can visibly see water left in the drum at the end of the wash then it s likely you have a blockage in the drain hose or the pump. If the lock the handle or the door itself does not have any visible damage it s time to proceed to the next step. Covid19 important information from hoover uk.

Clean or replace the hatch latch if the washing machine won t start the washing program. The pump may also be defective. Hoover service operations are continuing to operate but we are trying to strike a balance between following the government s advice to reduce the risk and spread of coronavirus and remaining operational. Washing machine door locks really only get 3 major faults 1 the points between live and common fail in some way.

Hoover washing machine e03 means that your washing machine has a draining issue. If so then you can try and replace the door lock and see if this cures the problem here. Take the door lock out from behind the door and check the wiring is ok on there. This fault may also be indicated by led lights flashing three times before pausing and then repeating.

Drainage as with all washing machines if the excess water cannot be drained away from the drum adequately not only will the cycle stop but the door will also lock. 2 the ntc heater or bi metal strip fail 3 the plastic gets to hot and distorts inside the lock causing it to jam. There are lots of different reasons why a washing machine door might refuse to budge including. Replace the door handle if the hook is broken.

Usually if you have the door lock light flashing its the lock itself thast the problem here. Some hotpoint and indesit machines have this anomaly.