Honda Door Lock Actuator Screws Stuck

The latch assembly gets corroded and when the pull lever cannot return fully to the rest position the latch assembly will not operate.

Honda door lock actuator screws stuck.

Remove this screw and unhook the tabs holding the black plastic housing for the actuator. Unclip and remove the inside door handle rod can t remember if i did this before or after unscrewing the locking mechanism. Observe the plastic tab above and beneath this screw. Unclip the broken actuator from the locking assembly.

Using a screwdriver test that the locking mechanism works by locking the latch then checking if the door latch releases using the outer handle lever. The 2010 honda cr v has 4 problems reported for door lock actuators failed. Take the inside door release lever panel off and push the lever rod all the way to the rear. There is many helpful tips and tricks to aid you in.

In some cars the door lock actuator is positioned below the latch. Install the lock subassembly onto the new door lock actuator using the new screws from the kit p n 72116 swa a01 and p n 72116 swa 003. Just unhook and slide through the holes on the metal. If you are having problems with your door locks this is the video for you make sure to watch until then.

Make sure the open link tab fits into the open link slot. The lock actuator is behind this screw. A rod connects the actuator to the latch and another rod connects the latch to the knob that sticks up out of the top of the door. Average repair cost is 610 at 84 500 miles.